TM 5-3610-286-20
Table 2-5. Organizational Troubleshooting (cont).
Malfunction
Test or inspection
Corrective action
14. DELIVERY GRIPPER BARS DO NOT GRIP PAPER PROPERLY.
Step 1.
Check for proper adjustment of delivery grippers.
Adjust grippers (para. 2-57).
Step 2.
Check for proper timing to impression cylinder.
Adjust timing (para. 2-57).
Step 3.
Check for damaged or missing components of delivery grippers.
Replace delivery grippers (para. 2-57).
15. DELIVERY PILE BOARD WILL NOT LOWER AUTOMATICALLY.
WARNING
HIGH VOLTAGE
Do not operate printing press until you are sure TSS Press Section is
connected to a suitable ground. Failure to do so may result in death or
serious injury.
l
Shut off power source before attempting to disconnect, service or con-
nect wires or cables. Failure to do so may result in death or serious injury.
l
When working on high-voltage components, always have an additional
person present, and keep one hand away from equipment to reduce hazard
of current flowing through vital organs of body. Remove all jewelry from
fingers, wrists, and neck prior to working on electrical components.
Failure to do so may result in death or serious burns.
Step 1.
Adjust delivery pile transport (para. 2-64).
If delivery pile board still will not lower automatically, go to step 2.
Step 2.
Press delivery pile down pushbutton (b23).
If delivery pile board lowers, go to step 3.
If delivery pile board does not lower, go to step 5.
2-41
