TM 5-3610-286-20
Table 2-5. Organizational Troubleshooting (cont).
Malfunction
Test or inspection
Corrective action
9. FEEDER AND SUCTION HEAD DO NOT RUN SMOOTHLY (cont).
Step 4.
Ensure drive chain has proper lubrication.
Lubricate in accordance with LO 5-3610-286-12.
Step 5.
Visually check chain sprockets for wear or damage.
Replace chain sprockets (para. 2-88).
10. FEEDER DOES NOT CUT OFF WHEN SHEETS ARE MISSING OR MlSFED.
Check light barrier for cleanliness and proper adjustment. If problem continues, replace
electronic control box (u2) (para. 2-92).
11. SHEETS FEED FORWARD, BUT ARE NOT GRIPPED CORRECTLY BY RANGER DRUM GRIPPERS.
WARNING
l
l
l
HIGH VOLTAGE
Do not operate printing press until you are sure TSS Press Section is
connected to a suitable ground. Failure to do so may result in death or
serious injury.
Shut off power source before attempting to disconnect, service, or con-
nect wires or cables. Failure to do so may result in death or serious injury.
When working on high-voltage components, always have an additional
person present, and keep one hand away from equipment to reduce hazard of
current flowing through vital organs of body. Remove all jewelry from
fingers, wrists, and neck prior to working on electrical components.
Failure to do so may result in death or serious burns.
Step 1.
Check timing between feeder and press (TM 5-3610-286-10).
Step 2.
Inspect ranger drum, head stop, grippers, and gripper bar.
Adjust and repair as needed (para. 2-67).
2-36
