TM 5-3610-286-20
Table 2-5. Organizational Troubleshooting (cont).
Malfunction
Test or inspection
Corrective action
12. IMPRESSION CYLINDER DOES NOT GRIP PAPER PROPERLY (cont).
Step 2.
Check for proper adjustment of grippers and adjust if required (para. 2-70).
Replace gripper pads (para. 2-70).
Step 3.
Check front lay alignment (TM 5-3610-286-10).
Step 4.
Inspect ranger drum, head strap, grippers and gripper bar.
Adjust and repair as needed (para. 2-67).
13. PRINTING PRESS DOES NOT PRINT WHEN IMPRESSION ON/FEEDER ON PUSHBUTTON (b70) IS
PRESSED.
l
l
l
WARNING
HIGH VOLTAGE
Do not operate printing press until you are sure TSS Press Section is
connected to a suitable ground. Failure to do so may result in death or
serious injury.
Shut off power source before attempting to disconnect, service or con-
nect wires or cables. Failure do so may result in death or serious injury.
When working on high-voltage components, always have an additional
person present, and keep one hand away from equipment to reduce hazard
of current flowing through vital organs of body. Remove all jewelry from
fingers, wrists, and neck prior to working on electrical components.
Failure to do so may result in death or serious burns.
NOTE
The following procedure is the same for the PRODUCTION pushbutton (b71).
The only difference is at steps 5 and 8 at which point perform the function using
the PRODUCTION pushbutton (b71).
Step 1.
Check for paper at front lay.
If no paper, check feeder.
If paper is found at front lay, go to step 2.
2-38
