TM 5-3610-286-20
2-75.
Blanket Cylinder Assembly (cont).
(2) Blanket cylinder drive gear. (figure 2-202)
NOTE
Gear is not repairable but must be removed to permit access to other,
repairable, press assemblies.
(a) Set press to “O” position.
(b) Place wooden blocks under blanket cylinder to prevent rotation when gear is removed.
(c) Remove six hex-head bolts (1) and washers (2).
(d) Remove two locator pins (3) and gear (4).
(e) Position gear (4) on press in “O” position and replace locator pins (3).
(f) Replace six washers (2) and six hex-head bolts (1).
(g) Remove wooden blocks.
2-412
