Figure 2-205.
TM 5-3610-286-20
(3) Blanket cylinder to impression cylinder adjustment. (figure 2-205)
(a)
(b)
(c)
(d)
(e)
Turn flywheel to put press in “0” position. (Lineup marks on drive gears).
Using manual lever, put press in impression ON.
Insert 0.35 mm feeler gage (1) between the bearer rings of the blanket (2) and
impression cylinders (3) at D/S and O/S.
Using special wrench (4), turn upper pressure adjusting ring (5) to set sealed bushings
(6) at D/S and O/S to “0”.
Turn hexagonal spacer bushing (7) of adjustment bolt until the steel gages can be pulled
out with slight binding.
2-417
