TM 5-3610-286-20
2-70.
Impression Cylinder Assembly.
This task covers:
a. Remove
b. Inspect
c. Repair
d. Install
e. Adjust
INITIAL SETUP
Tools
Equipment Conditions
Stud remover collet
Cylinder safety guard removed (para. 2-65)
Stud remover housing
Blanket cylinder drive gear removed
6 mm combination wrench
(para. 2-75)
17 mm combination wrench
Dial gage
a. Remove.
(1) Impression cylinder. (figure 2-185)
NOTE
Put press in “0” position with impression ON (TM 5-3610-286-10).
(a) Remove two cap screws (1) and gripper (2).
(b) Remove three socket-head screws (3), three washers (4) and cam (5).
(c) Remove two tapered pins (6), six cap screws (7), six washers (8), and gear (9).
(d) Remove grease fittings (10).
2-384
