TM 5-3610-286-20
2-69.
Impression Cylinder Control Mechanism.
This task covers:
a. Test
c. Disassembly
e. Assembly
g. Adjust
b. Remove
d. Repair
f. Install
INITIAL SETUP
Tools
Equipment Conditions
Retaining-ring pliers
Main guard (D/S) removed (para. 2-20)
Ball-peen hammer
Upper guard (O/S) removed (para. 2-18)
5 mm pin punch
Lower guard (O/S) removed (para. 2-19)
8 mm pin punch
Engaging lever latch assembly removed
5 mm hex key
(para. 2-71)
10 mm combination wrench
Ranger drum cams removed (para. 2-67)
13 mm combination wrench
17 mm combination wrench
19 mm combination wrench
Feeler gage
a. Test. Perform test in accordance with the instructions given in para. 2-10, Troubteshooting.
b. Remove.
(1) Impression cylinder control mechanism removal.
(a) Remove two hex nuts (1, figure 2-164).
(b)
Remove external retaining ring (2), flat washer (3), and operating rod (4).
2-362
