TM 5-3610-286-20
2-65.
Cylinder Safety Guard Assembly (cont).
d. Aline. (figure 2-152)
WARNING
(1)
(2)
EXPOSED MOVING PARTS. All adjustments will be made while printing press is
on SAFETY STOP except those authorized by this manual to be made with print-
ing press running. Printing press must be on safe at all times when not in
motion. Always shout “clear” and wait for “clear” response before taking print-
ing press off safe to inch or run. Failure to follow this warning may result in
serious injury.
With safety guard (1) in closed position, verify that plunger (2) on limit switch (3) is fully
depressed.
Loosen screws (4) on limit switch (3) and slide switch up or down, as required, until full
depression of plunger (2) is achieved by closing safety guard (1).
2-338
