TM 5-3610-286-20
2-65.
Cylinder Safety Guard Assembly.
This task covers:
a. Test
b. Remove
c. Install
d. Aline
INITIAL SETUP
Tools
Additional Personnel Requirement
5 mm hex key
Electrician MOS 35E20
0.050 x 0.375 x 8 in. fiat-tip screwdriver
No. 3 x 6 in. cross-tip screwdriver
10 mm combination wrench
a. Test.
(1) With safety guard in closed position, turn press on. Press should begin operating.
(2) With press running, lift safety guard. Press should stop running instantly.
(3) If press does not respond as described in steps (1) and (2), perform continuity test as
described in paragraph 2-16. Aline or replace switch as required.
b. Remove. (figure 2-150)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
2-334
Unlock two turnlock fasteners (1) and remove safety guard (2).
Remove four rivets (3), four cap screws (4), four fiat washers (5), and two guards (6).
Remove two screws (7) from switch cover (8) and open cover.
Tag wires for position identification and disconnect wires from switch terminals.
Loosen lock nut (9) and slide cable (10) out of switch (11).
Remove two screws (12) and remove switch (11) from bracket (13).
Remove two bolts (14) and remove bracket (13).
