TM 5-3610-286-20
2-66.
Cam Shaft Assembly (cont).
c. Install. (figure 2-154)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Install two needle bearings (1) in O/S and D/S frames.
Install cam follower (2), pin (3), and taper pin (4).
Slide shaft (5) through O/S frame, and install two spacers (6) and two cam levers (7) as
shaft passes into press. Slide shaft fully into bearing on D/S frame.
Install two threaded pins (8) and threaded pin (9).
Install hex nut (10), hex screw (11), two springs (12), and hex nut (13).
Install hex-head screw (14), spacer bushing (15), and hex nut (16), and instalI end of
hex-head screw (14) into threaded hole in O/S frame.
Install lever (17) and two taper pins (18).
Install cam (19) and flange (20) and aline with pin (21).
Install three washers (22) and hex-head screws (23), and three washers (24) and
socket-head screws (25).
NOTE
FOLLOW-ON MAINTENANCE:
(1) Install lower guard (O/S) (para. 2-19).
(2) Install upper guard (O/S) (para. 2-18).
2-342
