TM 5-3610-286-20
2-62.
Cam Lever Assembly.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Conditions
Ball-peen hammer
Delivery sheet stop assembly removed (para. 2-55)
6 mm pin punch
Lower guard door (O/S) open (para. 2-19)
10 mm combination wrench
Delivery plexiguard removed (para. 2-21)
5 mm hex key
a. Remove. (figure 2-140)
(1) Loosen hex nut (1) and socket-head screw (2).
(2) Remove end of tension spring (3) from screw (2).
(3) Remove taper pin (4) and lever (5).
(4) Remove two taper pins (6).
(5) Remove grease fitting (7) and retaining ring (8).
(6) Slide shaft (9) out through O/S side frame and slide levers (10) off of shaft (9).
b. Repair. (figure 2-140)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
2-316
Remove pin (11) and roller (12).
Remove hex nut (13), stop nut (14), washer (15), and lever stop (16).
Remove screw (17) and tension spring (3).
Remove retaining ring (18), washer (19), pin (20), and bearing (21).
Remove bearings (22) from side frames.
Replace binding bearings, broken tension spring, damaged or missing roller or lever stop.
Press bearings (22) into side frames.
Replace bearing (21), pin (20), washer (19), and retaining ring (18).
Replace tension spring (3) and screw (17).
Replace lever stop (16), washer (15), stop nut (14), and hex nut (13).
Replace pin (11) and roller (12).
