TM 5-3610-286-20
2-61.
Chain Sprocket Assembly (cont).
c. Install. (figure 2-139)
(1) Install bearing (1) on D/S of press side plate and replace two washers (2), and hex-head
cap screws (3).
(2) Install segment (4) on O/S of press side plate and replace two ribbed washers (5), and
socket-head cap screws (6).
(3) Install chain sprocket and bolt (7) into bearing (1) through O/S of press side plate.
(4) Install retaining ring (8).
(5) Install three socket-head cap screws (9) and flange (10)
(6) Install felt ring (11), pin (12), tacho dynamo drive shaft (1
flange (15), and two socket-head screws (16).
(7) Install powder spray cam (17) and hex nut (18).
(8) Tighten tensioning screw (19) and lock nut (20).
3), plate spacer (14),
(9) Install tacho dynamo (21), clamp (22), washer (23), and screw (24).
(10) Install tool tray (25) on press side plate and replace two hex-head screws (26).
NOTE
FOLLOW-ON MAINTENANCE:
(1) Install delivery plexiguard (para. 2-21).
(2) Close lower guard door (O/S) (para. 2-19).
(3) Install dust catcher (para. 2-53).
(4) Install delivery grippers (para. 2-57).
(5) Adjust delivery gripper chain tension (para. 2-57).
2-314
