TM 5-3610-286-20
2-61.
Chain Sprocket Assembly.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Condition
5 mm hex key
Delivery grippers removed (para. 2-57)
Retaining-ring pliers
Dust catcher removed (para. 2-53)
Ball-peen hammer
Lower guard door (O/S) open (para. 2-19)
5 mm pin punch
Delivery plexiguard removed (para. 2-21)
13 mm combination wrench
19 mm combination wrench
Additional Personnel Requirement
Electrician MOS 35E20
a. Remove. (figure 2-137)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
2-310
Remove two hex-head screws (1) and tool tray (2).
Remove screw (3), washer (4), clamp (5), and tacho dynamo (6).
Loosen lock nut (7) and tensioning screw (8).
Remove hex nut (9) and powder spray cam (10).
Remove two socket-head screws (11), flange (12), plate spacer (13), tacho dynamo
drive shaft (14), pin (15), and felt ring (16).
Remove three socket-head cap screws (17) and flange
Remove retaining ring (19).
Remove chain sprocket and bolt (20) out of bearing (21)
side plate.
(18).
and remove from O/S of press
Remove two socket-head cap screws (22), ribbed washers (23), and segment (24).
Remove two hex-head cap screws (25), washers (26), and bearing (21).