TM 5-3610-286-20
2-55.
Sheet Stop Assembly.
This task covers
a. Replace
b. Repair
INITIAL SETUP
Tools
Equipment Conditions
13 mm combination wrench
5 mm pin punch
Ball-peen hammer
Lower guard (O/S) door open (para. 2-19)
Delivery guard raised (TM 5-3610-286-10)
a. Replace. (figure 2-120)
NOTE
Replace and repair of the sheet stop assembly is the same for both D/S and
O/S. This procedure presents O/S removal.
(1) Remove ball handle (1).
(2) Remove retaining ring (2), tommy screw (3), and collar (4). Slide sheet stop (5) out of
guide sleeve (6).
(3) Remove two hex screws (7), bearing (8), and spring (9).
(4) Remove guide sleeve (6).
(5) Remove two hex screws (10) and guide piece (11).
(6) Install guide piece (11) and two hex screws (10).
(7) Install guide sleeve (6).
(8) Install spring (9), bearing (8), and two hex screws (7).
(9) Slide sheet stop (5) into guiding sleeve (6).
(10) Replace collar (4), tommy screw (3), and retaining ring (2).
(11) Replace ball handle (1).
2-278
