TM 5-3610-286-20
2-29.
Driving Mechanism.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Rubber mallet
Bushing driver set
Ball-peen hammer
8 in. bronze punch
13 mm combination wrench
Retaining-ring pliers
5 mm hex key
6 mm hex key
Equipment Conditions
Main guard assembly removed (para. 2-20)
Oscillator lever assembly removed (para. 2-26)
a. Remove. (figure 2-49)
NOTE
Zero set the printing press before beginning this procedure.
(1) Remove ball bearing (1).
NOTE
Match/mark the positions of the cams before performing step (2).
(2) Remove three socket-head screws (2), washers (3), dampening ductor roller cam (4),
and ink ductor roller cam (5).
(3) Remove spring tension pin (6), pinion gear (7), and spacer (8).
NOTE
Match/mark the positions of pinion gear (11) to flanged gear (12) before
performing step (4).
(4) Remove six socket-head screws (9), washers (10), pinion gear (11), flanged gear (12),
and two tapered bearings (13).
(5) Remove three socket-head screws (14) and bearing bolt (15).
2-140