TM 5-3610-286-20
2-27.
Swivel Lever Assemblies.
This task covers:
a. Remove
b. Repair
c. Install
d. Adjust
INITIAL SETUP
Tools
Equipment Conditions
5 mm hex key
Upper guard and accessories (O/S) removed
6 mm hex key
(para. 2-18)
3 mm pin punch
Inking form rollers removed
8 mm pin punch
(TM 5-3610-286-10)
Ball-peen hammer
Ink oscillator rollers removed (coupling type -
Flat-tip screwdriver
TM 5-3610-286-10, solid type, para. 2-33)
NOTE
All maintenance procedures are the same for both sets of swivel levers.
a. Remove. (figure 2-44)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
2-130
Remove two colored caps (1) and spacer bushings (2).
NOTE
There are two ball bearings (four total) in each journal box housing.
Remove two retaining rings (3).
Placing one hand under locking sleeves (4) to catch bearings (5), carefully remove
locking sleeve (4) and gasket (6), catching bearings that may drop from journal box (7).
Remove remaining ball bearings (5) from journal box (7).
Remove two retaining rings (8), two journals (9), and journal boxes (7) from inside
press. Remove shims (10).
Remove screw (11) and cable clamp (12). Place cable where it will not interfere with
maintenance being performed, Remove stop piece (13) and spring (14).
Remove two retaining rings (15), washers (16), and pull rod (17).
Remove six socket-head screws (18).
Loosen locking hex nut (19). Remove spring rod (20), spring (21), and washer (22).
Remove journal box housing (23), shims (24), and journal box housing (25).
