TM 5-3610-286-20
2-24.
Ink Fountain Assembly (cont).
(2) Ink roller. (figure 2-38)
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
Install needle bearing (1).
Install inner bushing (2) and outer bushings (3).
WARNING
Ink fountain roller exceeds 35 pounds and requires two persons for
installation.
CAUTION
When performing next step, use care not to loosen or damage O/S side plate
needle bearing.
Place supporting wooden blocks in press to hold ink fountain roller. Using two persons,
depress ink ductor roller stop lever (Sheet 2, 4) out of way. Slide ink fountain roller
(Sheet 1,5) through hole in D/S side frame into press until O/S end of roller shaft
passes through needle bearing (1) and bushings (2, 3) in O/S side frame. Rest roller
on support blocks.
Install washer (6) and clutch assembly (7) on ink roller (5).
Install washer (8) and snap ring (9).
Install spacer (10) and circular shims (11).
NOTE
Install same number of shims as were removed.
Install end cap (12), spacer (13), and needle bearing (14) with lubrication fitting
hole at top.
Install snap ring (15), three washers (16), and three hex screws (17).
Install D/S lubrication fitting (18) on end cap (12).
Replace flexible line lubrication fitting (19) on D/S lubrication distribution unit (20).
Install grease fitting (21) on ink fountain roller clutch (7).
2-116
