TM 5-3610-286-20
2-22.
Manual Inking Roller Assembly (cont).
c. Install.
(1) Manual inking roller assembly. (figure 2-28)
(a) Assure that support lever handles (1) are in roller down position.
(b) Using two persons, aline mounting bar (2) with holes in press side plates.
(c) Install hex-head extensions (3, 4) and tighten extensions.
NOTE
Hole in O/S hex-head extension (4) must be parallel to the ground when screw
is tight.
(d) Install fitting (5) in extension (4).
(e) Install flexible lubrication line (6) and hex nut (7) in fitting (5).
(f) Install plug (8) and fitting (9).
(g) Install hex nut (10) and rigid lubrication line (11) in fitting (9).
(h) Install D/S lubrication “tee” (12), two seals (13), and hex-head extension (14).
(i) Install rigid and flexible tube fittings in lubrication “tee” (12) and remove tags.
(j) Install mounting bracket (15), washer (16), and hex bolt (17).
(k) Mount lubrication distribution unit (18) on mounting bracket (15) and install and tighten
slotted mounting screw (19).
(l) Install all lubrication fittings to lubrication distribution unit (18) and remove tags.
2-96
