TM 5-3610-286-20
2-22.
Manual Inking Roller Assembly (cont).
(2) Manual inking roller assembly. (figure 2-26)
(a)
(b)
(c)
(d)
(e)
(f)
(9)
(h)
(i)
(i)
(k)
(1)
2-92
Tag and remove D/S tube fittings from manual inking roller lubrication distribution
unit (1).
Remove slotted mounting screw (2) from top of lubrication distribution unit (1) and
remove unit from bracket (3).
Remove hex bolt (4), washer (5), and mounting bracket (3).
Tag and remove rigid and flexible tube fittings from lubrication “tee” (6).
Remove hex-head extension (7), two seals (8), and lubrication “tee” (6).
Loosen hex-head extension (9).
CAUTION
Do not remove hex-head extension (9) at this time.
Loosen nut (10) and remove rigid lubrication line (11) from fitting (12).
Remove fitting (12) and plug (13).
Loosen nut (14) and remove flexible lubrication line (15) from fitting (16).
Remove fitting (16).
NOTE
Inch ductor roller swing mechanism out of way to perform step (k).
Loosen hex-head extension (17).
CAUTION
Do not remove hex-head extension (17) at this time.
Roller support levers (18) are loosen on mounting bar when
manual inking roller assembly is removed.
Using two persons, remove two hex-head extensions (9, 17) and lift manual
inking roller
assembly (19) out of press.
