Figure 2-30.
TM 5-3610-286-20
2-23.
Form Rollers Limit Switch.
This task covers:
a. Test
b. Remove
c. Install
d. Aline
INITIAL SETUP
Tools
Equipment Conditions
1 mm feeler gage
Upper guard (O/S) removed (para. 2-18)
Multimeter
0.050 x 0.375 x 8 in. flat-tip screwdriver
Additional Personnel Requirement
No. 2 x 4 in. cross-tip screwdriver
17 mm combination wrench
Electrician MOS 35E20
a. Test. (figure 2-30)
(1) Loosen two screws (1) and open hinged cover (2).
(2) Perform continuity test (refer to para. 2-16) holding test leads (3) against appropriate
terminal screws.
(3) If no continuity (in either plunger position), replace switch.
2-100
