TM 5-3610-286-10
3-5.
DAMPENING ROLLERS MAINTENANCE INSTRUCTIONS (CONT)
b.
Using bearing guide (1) and rubber mallet, tap spacer piece (2) onto
roller shaft (3).
c. Using bearing guide (1) and rubber mallet, tap bearing (4) onto
roller shaft.
3.
Lightly dust roller surface with talc.
4.
Slide new cover (1) on roller (2).
Leave 1-3/16 in. (3.0 cm) excess
length on both ends of roller.
NOTE
There are a wide variety of suitable seamless covers
available.
The fastening of cover to roller depends upon
type of cover being used.
The following step is for
synthetic shrinking roller covers.
3-23
