TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
e. Prepare Inking Assembly (Cont)
(7) Install Oscillator Roller No. 5
NOTE
Form roller no. 3 must be moved away from oscillator
roller no. 5 to prevent contact pressure between two
rollers.
(a) At delivery end, locate form roller no. 3 worm adjustment
screws on roller journal inside frame.
Turn worm adjustment screws to left
to move form roller no. 3 away from oscillator roller no. 5.
(b) Ensure open ends of oscillator roller no. 5 stub shafts are
facing upward.
(c) Position oscillator roller no. 5 so that sickle-shaped part on
shaft (1) faces up and toward operator side.
2-80
