TM 5-3610-285-14
Table 7-2. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
DENSITOMETER WILL NOT ENERGIZE.
Step 1.
Check that power cord is plugged in.
(a) If power cord is plugged in, proceed to step 2.
(b) Connect power cord.
Step 2.
Check position of power panel circuit breaker.
(a) If circuit breaker is on, refer to step 3.
(b) Reset circuit breaker.
WARNING
Death or serious injury may occur from electrical shock unless power cord is unplugged before
troubleshooting equipment.
Step 3.
Check for blown fuse.
(a)
If fuse is not blown, notify your supervisor.
(b)
Change fuse.
7-20
