TM 5-3610-285-14
b.
Transmission Probe.
NOTE
When switching probes, the calibration procedure for the probe selected must be performed prior to
operation.
(1) Locate the desired area of negative over the lighted aperture.
(2) Center desired area.
(3) Press upper portion of probe downward.
(4) Press and hold read pushbutton until a reading is obtained on the digital readout. If desired, move probe or
sample around, while holding the read pushbutton to obtain maximum and minimum values.
NOTE
The digital readout will automatically hold and display the last measured value when the read pushbutton
is released.
(5) Release read pushbutton when desired reading is obtained.
7-6.4
Preparation for Movement.
a.
Turn densitometer and probe OFF.
b.
Unplug densitometer power cord.
c.
Unplug transmission probe power cord.
7-18