TM 5-3610-285-14
h.
Tag and disconnect wires for vacuum pump.
i.
Loosen clamp and remove defective power cord.
j.
Install new power cord through clamp on side of vacuum pump and tighten down clamp.
k.
Reconnect wires to vacuum pump.
l.
Reinstall electrical cover plate on back side of vacuum pump.
m.
Reinstall strain relief bushing onto new power cord.
n.
Reinstall power cord into control box and snap strain relief bushing into place.
o.
Reconnect wires to rocker switch. Reconnect ground wire on bolt in control box, and secure with nut.
p.
Reinstall cover plate on underside of control box.
q.
Plug in power cord for vacuum control box.
6-51
