TM 5-3610-285-14
6-16.3 Replace Lift Arm.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Tool Kit, Light Machine Repair
Hex Head Key Wrench Set
Flat Tip Screwdriver
Needle Nose Pliers
SUPPLIES: Lift Arm
Cotton Twine, approximately 3 feet (Item 65, Appendix E)
a. Tie up glass frame with rope to prevent it from falling when lift arm is removed.
b. Carefully remove three E clips on pivot pin at base of lift arm.
c. Using pliers, carefully move pivot pin toward outside of vacuum frame.
d. Remove lift arm bracket from glass frame.
e. Remove E clip from lift arm bracket pin and remove pin and defective lift arm.
f. Install new lift arm, and lift arm bracket pin into lift arm bracket. Retain in place with E clip.
6-40