TM 5-3610-285-14
o.
Inspect all components for excessive wear or damage. Replace any defective components.
p.
Wash all components in warm, soapy water. Rinse well, and dry components thoroughly.
q.
Install drive chain to left end plate sprockets. Close link.
r.
Install roller stud to left end plate.
s.
Reinstall roller assemblies to their proper positions and retain with studs.
t.
Reinstall resilient roller assembly and retain with studs and nuts.
u.
Reinstall exit roller assembly, bearings and spacer. Insert shaft onto roller and retain with locking plates, springs,
screws, and washers.
v.
Reinstall washers, key, chain sprocket, collars, and drive shaft to end plates.
w.
Reinstall chain idlers and studs to left end plate.
x.
Adjust adjustable chain idler until chain is tight.
y.
Position main drive shaft collars against bearing in right end plate and sprocket. Tighten setscrews.
z.
Reinstall key, and inner gear to drive shaft. Tighten setscrew.
aa.
Reinstall main drive gear to main drive shaft.
ab.
Reinstall rack into processor.
5-223
