TM 5-3610-285-14
p.
Wash all components in warm, soapy water. Rinse, and dry components thoroughly.
q.
Install drive chain to left end plate sprockets. Close link.
r.
Install roller stud to left end plate.
s.
Reinstall roller assemblies to their proper positions. Retain with studs. Remove tags.
t.
Reinstall resilient roller assembly and retain with studs and nuts.
u.
Reinstall exit roller assembly, spacer, and bearings. Insert shaft and secure with springs, locking plates,
washers, and screws.
v.
Reinstall washers, key, chain sprockets, collars, and drive shaft to end plates.
w.
Reinstall chain idlers and studs to left end plate.
x.
Adjust adjustable chain idler until chain is tight.
y.
Position main drive shaft collars against bearing in right end plate and sprocket. Tighten setscrews.
z.
Reinstall key and inner gear to main drive shaft. Tighten setscrew.
aa.
Reinstall main drive gear to main drive shaft. Tighten setscrew.
ab.
Reinstall developer rack assembly into processor.
5-219
