TM 5-3610-285-14
i.
Pull wiring through strain relief and remove defective overtemperature thermostat.
j.
Apply a thin coating of thermal grease to sensing surface of new thermostat.
k.
Install new thermostat to developer heater. Secure with bracket and two screws.
l.
Push new wiring through strain relief and make connections at terminal block.
m.
Push strain relief downward until it seats firmly into frame.
n.
Replace drain header cover and secure with screws.
o.
Reinstall drain valve handles and secure with screws.
p.
Reinstall front control panel and secure with screws.
q.
Reinstall TRANSPORT SPEED control knob. Tighten setscrew.
r.
Turn on processor circuit breaker.
5-16.29 Replace Control Unit A1.
MOS: 35E, Special Electronic Devices Repairer
TOOLS:
Tool Kit, Electronic Repair
Cross Tip Screwdriver
Flat Tip Screwdriver
SUPPLIES: Control Unit A1
WARNING
Death or serious injury may occur from electrical shock unless processor circuit breaker
is turned off before servicing.
a.
Turn off processor circuit breaker.
5-186
