TM 5-3610-285-14
e.
Disconnect two power cord connectors.
f.
Remove bezel nut retaining circuit board assembly to bracket.
g. Remove control circuit board assembly.
h.
Install new control circuit board assembly in bracket and retain with bezel nut.
i.
Reinstall bracket and retain with screws.
j.
Plug in power cord connectors.
NOTE
Prior to reinstalling control knob, ensure that control shaft is turned fully to left (lowest position). Reinstall
control knob so that indicator points to lowest position.
k.
Reinstall DRYER TEMPERATURE control knob and retain with setscrews.
l.
Reinstall left and rear access panels.
m. Turn on processor circuit breaker.
5-143
