TM 5-3610-285-14
5-8.6 Oilite Bearings.
a.
Dryer drive shafts (4). Semiannually, apply one to three drops of light oil (S.A.E. 10 motor oil) (Item 32,
Appendix E) on shafts at bearings.
b.
End of detector rollers (4). Semiannually, apply one to three drops of light oil (S.A.E. 10 motor oil) (Item 32,
Appendix E) on shafts at bearings.
c.
Dryer bottom pulley bearing (1). Semiannually, apply one to three drops of light oil (S.A.E. 10 motor oil) (Item 32,
Appendix E) on shaft bearing.
5-9. TROUBLESHOOTING PROCEDURES.
a.
This table lists the common malfunctions which you may find during operation or maintenance of the film
processor. You should perform the test/inspections and corrective actions in the order listed.
b.
This manual cannot list all the possible malfunctions or every possible test/inspection and corrective action. If a
malfunction is not listed or corrected by a listed corrective action, notify your supervisor.
Table 5-2. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. ROLLERS DO NOT ROTATE WHEN DRIVE SWITCH IS TURNED ON.
Step 1. Check that circuit breaker is ON.
(a)
If circuit breaker is ON, proceed to step 2.
(b)
If circuit breaker is OFF, turn on circuit breaker.
Step 2. Check interlock drive switch for activation.
(a)
If interlock drive switch is activated, proceed to step 3.
(b)
If interlock drive switch is not activated, activate interlock
drive switch.
Step 3. Check TRANSPORT SPEED control setting.
(a)
If TRANSPORT SPEED control setting is correct, proceed to step
4.
(b)
If TRANSPORT SPEED control setting is too low, rotate TRANSPORT
SPEED control knob to the right.
5-65
