TM 5-3610-285-14
Section III. OPERATOR'S MAINTENANCE INSTRUCTIONS
5-8. LUBRICATION INSTRUCTIONS.
WARNING
Serious injury may occur if fingers, clothing, or other materials are caught in moving parts.
CAUTION
Do not get oil or grease on the racks or crossovers, or in the solution tanks. Damage to equipment or contamination
may occur.
NOTE
These lubrication instructions are mandatory.
5-8.1 Drive Chains.
a.
Detector roller. Apply a small amount of ball and roller bearing grease (Item 23, Appendix E) to the surface of
chains once a month.
b.
Main drive. Apply to the surface of main drive chains a small amount of ball and roller bearing grease (Item 23,
Appendix E) once a month.
5-8.2 Worm Drive Gears.
a.
Detector roller drive. Semiannually, apply a small amount of ball and roller bearing grease (Item 23, Appendix E)
to surface of gear teeth.
b.
Dryer drive. Semiannually, apply a small amount of ball and roller bearing grease (Item 23, Appendix E) to
surface of gear teeth.
5-8.3 Main Drive Shaft Bearings. Semiannually, apply four to five drops of light oil (S.A.E. 10 motor oil) (Item 32,
Appendix E) into oil cups on top of bearing housings.
5-8.4 Developer and Fixer Recirculation Pump Motors. Semiannually, apply several drops of light oil (S.A.E. 10 motor
oil) (Item 32, Appendix E) on top and bottom motor bearings.
5-8.5 Replenisher Pumo Motor. Semiannually, apply several drops of light oil (S.A.E. 10 motor oil) (Item 32, Appendix
E) into both oil wells.
5-64
