TM 5-3610-285-14
e.
Remove Y hose connector from back side of vacuum gage.
f.
Remove two mounting nuts from vacuum gage and remove defective vacuum gage, with bracket and y hose
connector, through top of control panel.
g.
Install new vacuum gage through top of control panel and place mounting bracket around gage so that mounting
studs fit through the holes. Attach in place with mounting nuts. Be sure gage is properly centered on panel.
h.
Reinstall Y hose connector on back side of vacuum gage.
i.
Carefully lift control panel onto its mount.
j.
Reinstall mounting screws for control panel.
k.
Rotate glass frame into horizontal position and lock into place wits frame release knob.
l.
Turn on power panel circuit breaker.
2-75
