TM 5-3610-259-14
5-6. OPERATION UNDER USUAL CONDITIONS.
5-6.1 Assembly and Preparation for Use.
a.
Clean work surface.
b. Plug power cord into electrical receptacle.
c.
Turn power switch on for light table use.
5-6.2 Operatinq Procedures.
a.
Changing work surface.
CAUTION
Safety stops have been included to prevent overtravel of table top and
damage to electrical wiring.
If drafting surface is in top position,
swing front edge of table top down to change work surface.
If light
table is in top position, swing front edge up to change work surface.
Table cannot be rotated until
(1) Pull cabinet assembly
(2) Loosen tilt lock until
cabinet assembly is swung out.
lock release ring and swing out cabinet assembly.
it clears table top assembly.
(3) Rotate table top to desired
(4) Tighten tilt lock to secure
(5) Return cabinet assembly to
position.
table top assembly in position.
its normal position under table top assembly.
(6) Press firmly on cabinet assembly front until cabinet assembly lock
clicks.
5-6.3 Preparation for Movement.
a.
Turn off power.
b. Unplug power cord.
Coil power cord and tape to table.
c.
Rotate table top assembly, if necessary, to be sure glass surface faces
upward.
d. Tighten
e.
Press fi
tilt lock to secure table top assembly.
rmly on cabinet assembly front until cabinet assembly lock clicks.
for open containers and loose items. Seal containers
f. Check cabinet drawers
and secure all loose items.
g.
Lock cabinet drawers.
5-10
