TM 5-3610-259-14
d. Carefully lift blower mounting plate aside to gain access to wire
connections under blowers.
e.
Remove bezel nut on top of blowers/heater switch and remove switch from
blowers/heater housing frame.
f. Tag and disconnect wire(s) from switch leading to defective light(s).
g.
h.
i.
k.
1.
m.
n.
o.
p.
Remove tape from bolt connector under blowers and tag and disconnect
wire(s) leading to defective light(s).
Remove pinch clamp on defective light(s) and remove light through top of
frame.
Install new light(s) through top of frame and hold in place with pinch
clamp.
Reconnect wire(s) using bolt connector under blowers, and retape bolt
connector.
Reconnect wire(s) to blowers/heater switch.
Reinstall blowers/heater switch into frame and attach with bezel nut.
Carefully reinstall blowers and blower mounting plate so that blowers’
exhausts fit through portal holes of frame, and screw holes on top
aline.
Reinstall pencil tray.
Reinstall blowers/heater housing front cover panel.
Plug in power cord.
3-27
