TM 5-3610-259-14
d.
e .
f.
g.
h.
i.
3-6.3
a.
After the plate has dried, apply a small amount of special gum solution to
the entire plate surface using a soft, clean cellulose sponge.
Polish the gum dry with clean, soft cheesecloth.
The plate is now ready for storage or the press.
Clean the formica tabletop and remove kraft paper that was used during the
gumming process.
If more plate processing is desired, repeat steps a-g.
If processing has been completed, perform your after operation PMCS (Table
3-1).
Preparation for Movement.
Place power switch in center position.
b. Remove and discard kraft paper from table surface.
c.
Perform after operation PMCS.
d. Remove and store all loose items.
3-6.4 Operatinq Instructions on Decals and Instruction Plates.
3-7. OPERATION UNDER UNUSUAL CONDITIONS.
This equipment is designed for operation
only in a controlled environment.
3-11
