TM 5-3610-259-14
Section V.
DIRECT/GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
1.5.1 REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT; AND
SUPPORT EQUIPMENT
1.5.1.1 COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
1.5.1.2 SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT; AND SUPPORT
EQUIPMENT.
No special tools; test, measurement, and diagnostic equipment; or sup-
port equipment are required for the repair of this Section at the Direct/General
Support level of maintenance.
Individual equipment requirements are covered in the
specific equipment chapters.
1.5.1.3 REPAIR PARTS.
Repair parts for this equipment are listed in TM 5-361O
259-24P, Repair Parts and Special Tools List (RPSTL), covering Organizational, Di-
rect Support, and General Support Maintenance for this equipment.
1.5.2 DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES
a. Troubleshooting at Direct/General Support Maintenance level is required to
maintain or restore the van body to operational readiness. Troubleshooting pro-
cedures for the air conditioner/heater are contained in TM 5-4120-367-14.
Troubleshooting for the trailer chassis is contained in TM 5-2330-305-14.
b .
The most common failures are covered in this section. Failures or malfunc-
tions not covered require that systematic evaluation and step-by-step analysis of
the problem be made to isolate the fault.
Table 1-6.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION/PROBABLE CAUSE
CORRECTIVE ACTION
1 .
PERSONNEL DOORS DO NOT CLOSE COMPLETELY.
Step 1.
Be sure that latch rollers rotate freely.
Replace latches.
Step 2.
Check to see if latch rods are bent.
Replace latch rods.
1-105
