TM 5-3610-257-14
6-6.
OPERATION UNDER USUAL CONDITIONS.
6-6.1.
Operating Procedures.
a.
Starting unit.
(1)
Plug in power cord.
(2)
Move POWER switch to on position.
(3)
Check that FWD/REV switch is in FWD position.
(4)
Adjust MOTOR SPEED control for satisfactory drying.
b.
Operating unit.
NOTE
Do not squeegee film. Feed into machine wet.
(1)
Center material to be dried, and squarely insert between two squeegee rollers.
NOTE
Guide large or long material from rear. Do not pull.
(2)
Remove film from rear.
c.
Stopping unit. Move POWER switch to OFF position.
d.
Removing jammed material.
(1)
With POWER switch in ON position, set FWD/REV switch to REV position.
(2)
When material is ejected, set switch to FWD position.
6-7.
OPERATION UNDER UNUSUAL CONDITIONS. This equipment is designed for operation
only in a controlled environment.
Section III. OPERATOR MAINTENANCE
6-8.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
6-9.
TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation or maintenance of the film dryer, or
its components. You should perform the test/ inspections and corrective actions in the order listed.
b.
This manual cannot list all the possible malfunctions or every possible test/inspection and corrective action. If a
malfunction is not listed or is not corrected by a listed corrective action, notify your supervisor.
6-11
