TM 5-3610-258-14
e.
Drain water storage tank.
f.
Remove defective immersion heater.
g.
Set new immersion heater thermostat to 70’F (21’C).
CAUTION
Damage to equipment may occur from fluid leaks unless threads of immersion heater are coated
with thread sealant prior to installation.
h.
Coat immersion heater threads with teflon thread sealant.
i.
Install immersion heater.
j.
Connect immersion heater power cable.
k.
Reinstall magnetic contactor cover.
l.
Install photographic processing sink (paragraph 5-16.11).
m.
Turn ON immersion heater circuit breaker.
5-57
