TM 5-3610-253-14
n.
Remove proximity switch mounting bracket.
o.
Remove defective proximity switch from mounting bracket.
Install new proximity switch on mounting bracket.
p.
Reinstall proximity switch and mounting bracket on cutter frame.
q.
r.
Reinstall cable holddown and secure with bolt.
s.
Pull cable through front frame opening and secure in place with cable
holddown and bolt.
t.
Reinstall SDA circuit board and secure with screws.
u.
Push cable through left side opening and then reinstall top front cover
plate.
v.
Carefully push and pull cable down and through left side frame so that
cable is through the bottom opening of frame nearest SCU.
w.
Reinstall cable shield.
x.
Reinstall drip plate.
Slide in PM unit and secure with top screws.
y.
z.
Reinstall power supply cover.
aa.
Reinstall excess cable in cable box and group cables together with wire
ties.
Reinstall cover on cable box .
ab.
Reconnect plug connector 11 on SCU.
ac.
ad.
Reinstall rear electronics enclosure cover.
Place operator key back into safety lock.
ae.
af.
5-592