TM 9-1290-357-15
COMBINED ORGANIZATIONAL, DIRECT SUPPORT,
GENERAL
SUPPORT,
AND
DEPOT
MAINTENANCE
REPAIR PARTS AND SPECIAL TOOLS LIST
INTRODUCTION
Section l.
B-3. Explanation of Columns
B-1. Scope
The following provides an explanation of columns
This appendix lists basic issue items, repair
in the tabular lists in Section II through IV:
parts, special tools, and equipment required for
the performance of organizational, direct support,
a. Source, Maintenance, and Recoverability
general support, and depot maintenance of the
C o d e s (SMR).
aiming circle M1, w/e.
(1) Source Code. Indicates the selection sta-
tus and source for the listed item. Source codes
B-2. General
used are:
This Basic Issue Items, Repair Parts, and Spe-
EXPLANATION
CODE
cial Tools List is divided into the following sec-
P
Repair parts which are stocked in or supplied
tions:
from
the
GSA/DSA,
or
Army
supply
sys-
tem, and authorized for use at indicated
a. Basic Issue Items-Section II. A list of i-
maintenance categories.
tems which accompany the aiming circle and are
Repair parts which are not procured or
M
required by the operator crew for installation,
stocked, but are manufactured at indicated
operation or maintenance.
maintenance categories.
Assemblies which are not procured or stocked
A
Note. Maintenance and operator's supplies, prescribed
as such but are made up of two or more
load allowance (PLA), repair parts, and special tools
units, each of which carry individual stock
and support equipment for organizational maintenance
numbers and descriptions and are procured
are not applicable.
and stocked and can be assembled by units
b. Repair Parts--Section III. A list of repair
at indicated maintenance categories.
parts authorized for the performance of main-
Parts and assemblies which are not procured
X
or stocked; the mortality of which is nor-
tenance at the direct support, general support,
mally below that of the applicable end
and depot level in figure and item number se-
item; and the failure of which should result
quence.
in retirement of the end item from the sup-
ply system.
c. Special ToolS , Test and Support Equip-
Repair parts which are not procured or
X1
ment--Section IV. A list of special tools, test
stocked, the requirements for which will be
and support equipment authorized for the per-
supplied by use of next higher assembly or
formance at the direct support, general support,
component.
and depot level.
X2
Repair parts which are not stocked. The in-
dicated maintenance category requiring such
d. Federal Stock Number and Reference Num-
repair parts will attempt to obtain through
ber Index--Section V. A list of Federal stock
cannibalization;
if
not
obtainable
through
cannibalizatilon,
such
repair
parts
will
be
numbers in ascending numerical sequence, fol-
requisitioned with supporting justification
lowed by a list of reference numbers appearing
through normal supply channels.
in all the listings, in ascending alpha-numeric
Repair parts authorized for local procurement.
C
sequence, cross-referenced to the illustration fi-
When not obtainable from local procurement,
gure number and item number.
such repair parts will be requisitioned
