TM 5-6675-331-14&P
4-26. ELECTRICAL RECEPTACLES. (Cont'd)
a. Remove. (Cont'd)
4.
Loosen two screws (3) and pull receptacle (4) out far enough to gain access to terminal screws (5) and (6).
NOTE
Tag all wires before disconnecting.
5.
Loosen power terminal screws (5) and ground terminal screw (6) and disconnect wires (7) and (8).
6.
Remove receptacle (4).
b. Replace.
1.
Loosen power terminal screws (5) and ground terminal screw (6).
CAUTION
Ensure that wires are securely wrapped clockwise around power terminal screws and ground screw, and
that ends of wires do not stick out. Failure to do so may result in damage to equipment.
2.
Install power wires (7) and tighten screws (5).
3.
Install ground wire (8) and tighten screw (6).
4.
Install receptacle (4) and tighten screws (3).
5.
Install cover plate (2) and screw (1).
6.
Turn on Main Switch.
7.
Turn on receptacle circuit breaker.
8.
Test receptacle for power.
4-20
