TM 5-6675-328-14
a.
Remove nut and lockwasher from shaft.
b.
Remove latch rod actuator and two latch rods.
c.
Remove screw and lockbar.
d.
Remove nut and housing.
e.
Remove handle/shaft and cup.
f.
Remove lock retaining nut and lock.
g.
Install new lock and attach to door with lock retaining nut.
h.
Install new cup and handle/shaft with handle in closed position.
i.
Check that alinement tabs on housing are inserted in notches cut in door and attach housing finger tight with nut.
j.
Install lockbar and secure with screw.
k.
Insert latch rods into guides located at top and bottom of door.
l.
Install latch rod actuator on shaft with pins facing front of door and guide latch rod ends on upper and lower
actuator pins.
m.
Secure latch rod actuator against housing with lockwasher and nut.
9-9
