TM 5-6675-328-14
e.
Remove drawbar from headstock.
f.
Remove screws retaining belt shield to headstock and move shield to allow clearance.
g.
Slide motor and shield to the rear..
h.
Loosen eccentrics and slide headstock off lathe bed.
i.
Install new headstock on lathe bed.
j.
Reinstall belt, aline pulley, and tighten headstock eccentrics.
k.
Reinstall belt shield and secure with retaining screws.
l.
Reinstall drawbar in headstock.
m.
Slide motor to the rear. Adjust belt to remove all slack, and tighten retaining nuts.
n.
Reinstall cover on shield and secure with retaining screws.
o.
Plug in power cord.
5-34
