TM 5-6675-328-14
e.
Slide motor forward and remove drive belt.
f.
Remove socket head setscrew from pulley and remove pulley from motor.
g.
Remove motor and bracket from base.
h.
Remove screws and bracket from motor and retain.
i.
Reinstall bracket on new motor.
j.
Reinstall motor on motor base and install retaining nuts and washers finger tight.
k.
Reinstall pulley on motor shaft, aline with flat surface on shaft, and tighten setscrew.
l.
Reinstall drive belt.
m.
Slide motor to rear until all belt slack is removed, position so that pulley clears shield, and tighten motor
mounting nuts.
n.
Rotate pulley to be sure pulley does not rub on shield. Reposition motor or pulley as necessary.
o.
Reinstall cover and three retaining screws.
p.
Reinstall controller cord to motor.
q.
Plug in power cord.
5-30
