TM5-6675-326-14
6-6.2.18 Measuring Areas To Be Added and/or Subtracted - Continued
g.
Trace boundary line of shape using dot on lens tracing
assembly.
Stop when you reach starting point.
h .
Press foot switch to activate Print command.
NOTE
C a l c u l a t o r w i l l p r i n t d a t a o n a r e a j u st
measured.
It prints area of single shape
in square feet first followed by area in
square feet and acres.
C u r r e n t t o t al
areas are printed in same order.
i .
If area is to be subtracted instead of added, press ~ a nd
c f o r A c t u a t e r o u t i n e .
Repeat measurement procedure.
6-6.2.19 Measuring Surface Area of Slope
a. Assemble QPS with planimeter.
b.
Activate QPS:
(1) Plug foot switch into PRINT input jack on back panel
o f a u t o - s c a l e r.
(2) Plug remote tracer switch into ACCU input jack on back
panel of auto-scaler.
(3) Plug planimeter into E2 e n c o d e r s o c k e t o n b a c k p a n el
o f a u t o - s c a l e r.
( 4 ) P l u g p o w er
hack panel
(5) Plug power
(6) Plug power
( 7 ) P l u g p o w er
transformer cable into POWER supply jack on
o f a u t o - s c a l e r.
t r a n s f o r m e r c a b l e i n t o w a l l o u t l e t .
cord into back of calculator .
c o r d i n t o w a l l o u t l e t .
(8) Set encoder OFF/E2 / E1 switch on back panel of
a u t o - s c a l e r t o E2 .
(9) Set AUDIO/OFF switch on back panel of auto-scaler to
AUDIO .
(10) Set auto-scaler B/ACCU/A/OFF switch to A.
(11) Set auto-scaler MAN/AUTO switch to MAN.
6-59
