TM5-6675-326-146-6.2.14 Alinement of Planimeter With Lens Tracing Assembly. Alinementof the planimeter provides information needed to make area and volumemeasurements.Using the testing procedure provides values needed to checkalinement with factory determined values and provides a constant indetermining additional measurements and calculations. Test measurement ismade with the test rule. Measurement with test rule traces a circle witha two-inch radius. The area of that circle has a factory determined area,AT, found on the Calibration Records Sheet provided with the equipment.a. Assemble QPS using the planimeter with lens tracingassembly.b .Activate QPS:( 1)( 2)( 3)( 4)( 5)( 6)( 7 )( 8 )( 9)( l o )( 1 1)( 1 2)( 1 3)( 1 4 )( 1 5 )(16 )Plug foot switch into CLEAR input jack on back panel ofa u t o - s c a l e r.Plug remote tracer switch into ACCU input jack on backpanel of auto-scaler.Plug planimeter into E1 encoder socket on back panel ofa u t o - s c a l e r.Plug power transformer cable into POWER supply jack onback panel of auto-scaler.Plug power transformer cable into wall outlet.Plug power cord into back of calculator.Plug power cord into wall outlet.Set encoder OFF/E2/ E1 s w i t c ha u t o - s c a l e r t o E1 .Set AUDIO/OFF switch on backAUDIO .Set auto-scaler B/ACCU/A/OFFon back panel ofpanel of auto-scaler toswitch to A.Set auto-scaler MAN/AUTO switch to AUTO.Set auto-scaler X MEMORY switch to 1.Set calculator OFF/ON switch to ON.Set calculator MAN/TRACE/NORM switch to NORM.Set calculator PRGM/RUN switch to RUN.Press following keys:6-50
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
