TM5-6675-326-14
2-6.1 Assembly and Preparation for Use - Continued
(f) Remove center accumulator roller by pinching spring -
loaded latches and lifting from between view stages.
(g) Move stage separation knob to right. Make sure that
view stages close and knob locks into slot.
(h) Thread film leader over rollers across view stage to
t a k e - u p r e e l .
(i) Adjust drag brake knobs on crank handles until fil m
t e n s i o n i s s u i t a b l e f o r o p e r a t o r ’ s u s e .
NOTE
Perform steps (j) through (n) to view
d u a l f i l m s t r i p s .
( j ) M o u n t r e a r f i l m s u p p l y r e e l o n i d l e r b r a c k e t . R e el
key slot engages bearing on idler bracket.
( k ) S l i d e r e a r d r i v e r b r a c k e t t o f r o n t u n t i l d r i v e
spindle engages reel key slot.
( l ) T i g h t e n b l a c k k n u r l e d l o c k i n g k n o b o n d r i v i ng
b r a c k e t .
( m ) I n s t a l l t a k e - u p b r a c k e t a t o p p o s i t e e n d o f s p l i t-
s t a g e l i g h t t a b l e .
( n ) T h r e a d r e a r f i l m s t r a n d .
2-25
