TM 5-6675-325-14
d.
e.
f.
g.
h.
i.
j.
k.
1.
m.
n.
Remove cable retaining screw.
Mark exact position of encoder on inside walls of encoder housing.
Remove two hex head screws on side of housing.
Remove defective encoder from housing.
Install new encoder in housing.
Make sure the new encoder is parallel with the bottom of the housing and placed exactly between
the marks made on the housing.
Reinstall two hex head screws on side of encoder housing.
Insert cable in housing. Reinstall cable retaining screw.
Reinstall cable bracket. Secure with screw.
Slide encoder housing onto mounting bar of planimeter.
Tighten thumbscrew holding encoder housing on planimeter.
5-144
Change 1
