TM 5-6675-325-14
3-16.9 Adjust Bed C utter.
MOS: 41B, Topographic Instrument Repair Specialist
TOOLS: Cross Tip Screwdriver
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing
a.
Unplug power cord.
b. Remove rear paper load
Left and riqht
reader-printer.
ing door.
NOTE
on bed cutter adjustment are viewed from rear of
c.
Reach into reader-printer over top of rollers, and use your finger
to feel approximate distance that bed cutter overlaps cutter frame.
Check left side first.
Bed cutter should slightly overlap. Check
right side.
This should be greater than left side. Precise mea-
surements are 0.005 in. (0.127 mm) for left and 0.015 in. (0.381 mm)
for right.
You will not be able to determine bed cutter overlap to
this order of accuracy.
Approximate measurements are adequate.
3-77
